Ender 3

I know this isn't what your asking for, but for what it's worth.... I tried every leveling "trick" in the book with my original Ender. I even mounted a dial caliper to the print head and leveled that way to be SUPER precise. I only quit having adhesion issues when: I upgraded my bed with a good piec

Ya the issue mainly is people dont want to tinker and tune when they buy a product. Especially when they see printers now like bambu which basically just work perfect out of the box. You also pay for that pleasure. Ive had friends ask me if they should get into 3d printing or should they get an ende

My Ender 3v2 has been working pretty flawlessly and consistent over the last 3 years I had it. Upgrades I made directly out of the box: Auto Bed Leveling usingthe CR Touch upgrade from Creality replaced the bed leveling springs with silicone washers (also from Creality) replaced the plastic filament

I love mine, but don't buy that. 1st gen doesn't have automatic bed leveling, and the heaters run off 12v. It takes ~10 minutes to preheat the bed and nozzle, so you won't really test much in 5 minutes. Creality sells factory refurbished Ender 3 V3 SE on eBay for $86 delivered to the US. It comes wi

Here's what nobody will actually tell you... Basically each and every Ender 3 bed is going to be a taco. It's not actually going to be flat because these are rolled aluminum from the factory. So when you heat them up they basically remember the fact that they were rolled and they basically become ta

Update: I Figured it out. After installing the Creality Sprite, there was a peripheral that needed a major change. Estepps/mm needed to be changed from 0.0 to 424.9 specifically. Made this adjustment and found a kick ass Cura profile specifically for the Ender 3 pro and holy shit, is she printing li

There are two main types of 3D printers: Resin and FDM. Based on what you mentioned about him, an FDM printer would be the better choice. Before buying, you can casually ask him what kind of printer he prefers. For example, ask which printer he uses at his office or which one he likes working with.

I'm glad to know that I didn't fuck up the assembly process and that having to manually level the printbed all the time is just par for the course on the creality ender 3

I have seen this issue so often recently that I have created this copy /paste reply. Everything that follows assumes that you have a clean and dry bed, and dry filament, and that everything is tight. Your first layer is critical for the rest of your print. At least on my Ender3 v3 SE, the built-in L

After you install the CRtouch sensor, you want to remove the Z limit switch completely. Disconnect it from the frame of the printer and disconnect the wires from the mainboard. The next thing you need to do is update the firmware to a version that supports your mainboard with a CRtouch added. In the