Neptune 3 Pro

I went from an elegoo neptune 3 to the p1s with ams. My gawd, i cant believe the difference. The p1s is so much better, easier, faster, more intuitive than the nep3. The differences between the p1 and the p2 would be wasted/lost on me. I couldnt be happier. I know there are "better, faster, quick ch

Depends on what you’re printing. In my experience, if it’s anything more than simple geometry and bigger than a baseball, it’s probably gonna take hours. Ultimately it all comes down to slicer settings. Maybe try a different slicer? I use the one from elegoos website ( Cura ) and I don’t update it,

That pretty much sums up why I stopped working on their Marlin firmware, that mess sucks. I had the plan to fix various flaws, but it's always this display implementation that comes in way and makes everything a huge pain. If I had continued with Marlin, I would have thrown away the LCD and replaced

This is what kept happening to any of my matte filament. But now I’m wondering if my nozzle was just really built up cause yeah that needle was stuck good before it snapped off inside. 😩 I swear I’m not even new to printing lmao. This is my 3 machine over the last 5 years. I went from an Elegoo Nept

I have a 3Pro. I ran into an issue in Cura where if I design a cylinder with 3 walls (a screw-top pot, actually) then Cura insists on doing a full 360deg travel move around the model immediately before the next outer layer, regardless of wall printing order setting, causing underextrusion at the Z s

Don’t worry mate I’m joking. Thanks for your idea, really appreciate it. However I’m looking for something to dry my filament while it’s printing. I have a Elegoo Neptune 3pro and that’s kinda slow so even normal prints will take a long time