K1C

I just went through all these same issues with my k1 max upgrade. So many small changes needed from ptfe tube, orca slicer printer codes, new cfs extruder and cut module, and cfs feeder/splicer jamming and feeding wrong. Finally still working 80% of the time with Minor ghost feeding and retracting w

I changed and updated my extruder to good gears and all that on my k1c and this is what I've found with certain filaments like petg and exocit pla, you have to do lid open printing, is the short answer. When printing fully enclosed the machine heatsyncs, extruder gears warm up, and instead of grabbi

I have the K1C Im sure I just had bad sources for taking apart the extruder. Creality wiki especially threw me off thats where i got the first pic and it was under k1c clogging issues. https://wiki.creality.com/en/k1-flagship-series/k1c

Both are the same Ender v3 SE. Its the same printer. Ender v3 SE can do pla, petg, and tpu fairly well. If you want to do abs, Asa, or PC, or other termal warping filiments. You should move more to an enclosed printer. Tbh, you can get a k1 for less than a hundred bucks more and then the world Is op