K1C

I just went through all these same issues with my k1 max upgrade. So many small changes needed from ptfe tube, orca slicer printer codes, new cfs extruder and cut module, and cfs feeder/splicer jamming and feeding wrong. Finally still working 80% of the time with Minor ghost feeding and retracting w

I changed and updated my extruder to good gears and all that on my k1c and this is what I've found with certain filaments like petg and exocit pla, you have to do lid open printing, is the short answer. When printing fully enclosed the machine heatsyncs, extruder gears warm up, and instead of grabbi

Fwiw after 4 printers I ended up with a creality k1 . Been using it round the clock for the last year. Occasionally jams. Otherwise love it compared to the other machines I’ve owned.

The linear rail upgrade on the KE has a few benefits, as mentioned is a bit lighter, they don't loosen up, and are a little more stable. Downfall is if the bed frame is printed from PETG, long-term 65°C prints will cause the bed to sag and requires constant leveling. Best if printed from PC-CF or AB

I have the K1C Im sure I just had bad sources for taking apart the extruder. Creality wiki especially threw me off thats where i got the first pic and it was under k1c clogging issues. https://wiki.creality.com/en/k1-flagship-series/k1c

Both are the same Ender v3 SE. Its the same printer. Ender v3 SE can do pla, petg, and tpu fairly well. If you want to do abs, Asa, or PC, or other termal warping filiments. You should move more to an enclosed printer. Tbh, you can get a k1 for less than a hundred bucks more and then the world Is op

The original K1 max would not work. I upgraded to the 2025 versions on the PCB board and hot end. Works great now. I think there's something different about the pcb board other than the connectors for the hot end. Creality 2025 K1 Max/K1/K1 SE/K1C Hotend Upgrade Ceramic Heating Block, Official New V

The original K1 max would not work. I upgraded to the 2025 versions on the PCB board and hot end. Works great now. I think there's something different about the pcb board other than the connectors for the hot end. Creality 2025 K1 Max/K1/K1 SE/K1C Hotend Upgrade Ceramic Heating Block, Official New V

I use H2C, Creality (K1,K1 Max, K2 Plus) and have used Anycubic Vyper and S1 Combo printers. I use H2Cs when I need the capabilities but tend to use the Creality boxes first in production and Bambu second. The H2C print quality is great but it takes quite a while to start its print cycles and it is